Directions:
# Beads Needed for Santa:
Peach - 2
Red - 47
Yellow - 1
Green - 10
Light Blue - 2
Black - 20
White - 33
| # Beads Needed for the Snowman:
Red - 11
Orange - 1
Green - 24
Light Brown - 13
Black - 4
White - 61 |
# Beads Needed for the Gingerbread Man:
Red - 1
Green - 13
Light Brown - 79
Brown - 2
White - 14
| # Beads Needed for the Star:
Red - 1
Pastel Yellow - 60
Cheddar - 60
Green - 10 |
# Beads Needed for the Tree:
Red - 5
Cheddar - 16
Green - 71
| # Beads Needed for the Snowflake:
Red - 24
Green - 18
White - 4 |
1. Download the Tree Ornaments II Project Pattern. Use the small square, small hexagon, and small star pegboards for your projects. If you’re using a clear pegboard, slide the actual-size pattern underneath it. Place all the beads for the design.
2. Cover the completed design with the ironing paper. Keeping the iron level, gently iron the beads in a circular motion for about 10 seconds to fuse the beads evenly. Ironed properly, the beads will still have an open center. DO NOT OVER-IRON the beads as it will make the centers of the beads close and can make it difficult to add the hangers.
Warning: Parents—the ironing must be done by an adult only. Some irons may emit steam. Please keep children at a safe distance.
3. Once the design is cool, peel off the ironing paper. Lift your design from the pegboard; flip the design over and repeat step #2. Your pegboards and ironing paper are reusable.
4. Assembly: Insert a short length of a chenille stem and curve to make a hook. You can also use a wire ornament hanger if you prefer.
For the star, use a piece of thread to dangle the tree inside the star.