Red Raider

Directions:

# Beads Needed:
Red - 515
Black - 68
White - 150
Clear - 6


1. Download the Red Raider Project Sheet. Use the large square and small hexagon pegboards for your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Now, place all the beads for the design.

2. Cover the completed design with the ironing paper. Keeping the iron level, gently iron the beads in a circular motion for about 10 seconds to fuse the beads evenly. Ironed properly, the beads will still have an open center. On a 3-D project such as this, DO NOT OVER-IRON the beads as it will make the centers of the beads close and can make assembly difficult. Warning: Parents—the ironing must be done by an adult only. Some irons may emit steam. Please keep children at a safe distance.

3. Once the design is cool, peel off the ironing paper. Lift your design from the pegboard; flip the design over and repeat step #2. Your pegboard and ironing paper are reusable.

4. GENTLY slide the bottom wing through the body of the plane. 


5. Attach the wing struts to the upper wing. 


6. Attach the upper wing to the lower wing.



7. Slide on the propeller and tail fin.




8. GENTLY push the wheels onto the landing gear segment and then slide the whole assembly to the plane.