Directions:
# Beads Needed for the Yellow Buggy:
Pink - 18
Plum - 10
Cheddar - 85
Yellow - 9
Kiwi Lime - 6
Pastel Lavender - 6
Black - 60
Clear - 30
| # Beads Needed for the Pink Buggy:
Magenta - 92
Plum - 26
Cheddar - 2
Kiwi Lime - 12
Black - 60
Clear - 32
|
# Beads Needed for the Surfboards:
Hot Coral - 27
Orange - 57
Cheddar - 4
Yellow - 112
Kiwi Lime - 131
Turquoise - 85
| # Beads Needed for the Crab:
Pastel Blue - 11
Light Blue - 33
Dark Blue - 18
White - 6
Black - 2
|
# Beads Needed for the Suntan Lotion:
Hot Coral - 49
Orange - 1
Cheddar - 4
Yellow - 12
White - 9
| # Beads Needed for the Sun:
Magenta - 42
Orange - 42
Cheddar - 52
Black - 9 |
# Beads Needed for the Dolphin:
Toothpaste - 17
Light Blue - 104
Black - 1
White - 14
| # Beads Needed for the Waves:
Transparent Turquoise - 178
Blue Glitter - 33
Clear - 87
|
1. Download the Beach Buggies Project Patterns. You will use the following pegboards: daisy, dolphin, car, small circle, small square, and large square. If you’re using clear pegboards, slide the actual-size pattern underneath them. Now place all the beads for your project. To create the waves, you will need to assemble TWO large square pegboards as shown of page 4 of the Project Patterns. Cut out the two individual halves of the wave charts and tape them together so that you can see the whole design at once.
2. Cover the completed design with the ironing paper. Keeping the iron level, gently iron the beads in a circular motion for about 10 seconds to fuse the beads evenly. Ironed properly, the beads will still have an open center.
Warning: Parents—the ironing must be done by an adult only. Some irons may emit steam. Please keep children at a safe distance.
3. Once the design is cool, peel off the ironing paper. Lift your design from the pegboard; flip the design over and repeat step #2. Your pegboards and ironing paper are reusable.