# Beads Needed for the Chair:
Light Pink - 28
Pastel Yellow - 38
Purple - 12
White - 150# Beads Needed for the Table:
Light Pink - 80
Pastel Yellow - 125
Purple - 12
White - 57
1. Download the 3-D Dollhouse Table and Chair Project Pattern. Use the large square pegboard for your project. If you’re using a clear pegboard, slide the actual-size pattern underneath it. Place all the beads for the design.
2. Cover the completed design with the ironing paper. Keeping the iron level, gently iron the beads in a circular motion for about 10 seconds to fuse the beads evenly. Ironed properly, the beads will still have an open center. On a 3-D project such as this, DO NOT OVER-IRON the beads as it will make the centers of the beads close and can make assembly difficult. Warning: Parents
—the ironing must be done by an adult only. Some irons may emit steam. Please keep children at a safe distance.
3. Once the design is cool, peel off the ironing paper. Lift your design from the pegboard; flip the design over and repeat step #2. Your pegboard and ironing paper are reusable.??
4. ASSEMBLY—All assembly is tab and slot. For the chair, insert the tab of the chair back into the slot on the seat with the pieces at right angles to each other. Slide the chair legs onto the assembled seat/back.??
For the table, turn the leg pieces at right angles to each other and align them slot to slot. Slide together. Then slide the table top onto the assembled legs.