Directions:
1. Trim a piece of green cardstock to 4 inches x 12 inches.
2. Place the cardstock in the upper left corner of the scoring board. Score at 3 inches, 6 inches, and 9 inches.
3. Cut four pieces of black cardstock to 3 3/4 inches x 2 3/4 inches. Adhere one black piece to each of the four panels on one side of the accordion card.
4. From the Halloween transfer sheet, cut out, center and apply the "Happy Halloween" transfer onto the first panel. Then apply the yellow flocking to it. Cut out and apply the pumpkin transfer onto a scrap of black cardstock and apply orange flocking. Cut out the pumpkin shape with scissors, leaving a thin border of black cardstock.
5. Cut out and apply a wrapped candy transfer onto a scrap of black cardstock and apply yellow flocking. Cut out the candy shape with scissors, leaving a thin border of black cardstock. Apply the rest of the candy and the bat transfers directly onto the first panel as shown. Apply 3D-Dots to the back of the cut-out pumpkin and candy, and adhere them to the panel as shown.
6. Apply three gravestone transfers onto black cardstock and apply green flocking. Trim and mat with green cardstock. Apply a small bat transfer to a scrap of black cardstock and apply green flocking. Cut out the bat, leaving a thin border of black cardstock. Use a 3D-Dot on the back of the bat and assemble the second panel as shown.
7. Cut out and apply a larger bat transfer onto a scrap of black cardstock and apply yellow flocking. Then cut around the bat shape with, leaving a thin border of black cardstock. Directly apply three star transfers to the third panel as shown and apply yellow flocking to them. Use a 3D-Dot to adhere the bat as shown.
8. Cut out and apply the “boo” transfer onto a scrap of black cardstock and apply orange flocking. Trim and mat on orange cardstock, leaving room on the side for the ghost transfer. Cut out and apply a small ghost transfer onto a scrap of black cardstock and apply orange flocking. Then cut around the ghost shape with scissors, leaving a thin border of black cardstock. Use a 3D-Dot to adhere it to the “boo” panel as shown.
9. Use a circle cutter to cut photos and adhere to the panels as shown using 3D Dots.