Dual Temperature Setting Glue Gun
Our dual-temperature glue gun allows you to change the setting to fit your materials. Switch it on high for a stronger bond that is best used with wood, plastic, metal, ceramics, magnets, leather, and fabric. Set it to low for more delicate materials such as lace, foil, ribbon, floral foam and lightweight fabric, or paper.PLEASE READ ALL INSTRUCTIONS AND WARNINGS BEFORE USE.INSTRUCTIONSWARNING! When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury.
 Always disconnect glue gun when not in use.
 Gun is ON when plugged in. Never leave unattended
 Do not use hot melted glue to replace structural fasteners.
 Do not use with extension cords.
 Do not use any material other than recommended sticks.
 Avoid accidental discharge. Do not touch glue stick or trigger except to dispense glue. Feeding or pushing glue stick with too much force into heated gun may cause hot glue to be unexpectedly expelled from nozzle or to flow back from inlet tube.
 Always allow glue gun to cool before storing..
 Make sure the work environment is dry, clean, well lit, and clear of any flammable materials.
 NEVER use outdoors or near water.
 Do not expose glue gun to rain, moisture, or direct sunlight.
 KEEP AWAY FROM CHILDREN and store locked up when not in use.
 Do not carry gun by cord or unplug from outlet by pulling electrical cord.
 Set switch to desired temperature; plug into electrical outlet.
 Insert 5⁄16 in diameter glue stick into the inlet tube.
 Allow gun to heat for 5 minutes.
 Squeeze trigger to dispense glue. By pulling trigger back more glue is dispensed.Add additional glue sticks to continue glue flow.
 Within 15 seconds, press surfaces to be glued together.
 Do not pull glue sticks from gun. If changing glue, feed remainder of glue stick through gun.
 Unplug after use and allow to cool before storing.
 Switch on high setting for stronger bond. Switch on low for bondingdelicate materials. High-temperature glue gun is best used with wood, plastic, metal, ceramics, magnets, leather, paper, fabric and other porous and non-porous materials. Low temperature is best used with lace, foil, ribbon, floral foam, lightweight fabric, and other delicate materials.
CAUTION Do not touch heated nozzle or melted glue as the temperature can reach 400 degrees F.If accidental contact occurs, do not remove glue. Immediately put burned area into cold water. Always wear protective clothing, safety glasses, gloves, long sleeve shirt, and long pants. KEEP OUT OF REACH OF CHILDREN. KEEP AWAY FROM FLAMMABLE MATERIALS. Manufacturer assumes no responsibility for consequential or indirect damages from the use of this product.