Skip to content

  • lemonade tulip ring

    View larger

  • Lemonade Tulip Ring

    Designed By Leslie Boyer

    Wear some sunshine on your finger with this sweet lemonade ring made with this fun ring made with the Flowers and Brass collection.   This collection allows you to mix an match pieces to get the just the look and colors you desire! 

Directions:

 1. Thread a piece of wire (7 inches) through a crystal to the middle of the wire and bend together. Now pass this wire through your flower and then through the ring. (see tip below)

2. Weave the wire end through several holes in the ring base to secure your work. Trim excess wire and use chain nose pliers to finish tucking the wire end into the top of the brooch base, under each crystal and flower component.

3. Repeat the above step with all of your flower groupings.

Tip:
Start wiring your first flower in the center and work the other flowers around that one.

Shopping List


Other Supplies

  •  26 Gauge Wire

You are now leaving the site.