1. Cut an 18” piece of wire and thread through all of your large petals. Twist the wire a couple of times and wrap it several times in between all of the petals going in a circle. This will tighten the flower. Twist and trim wire on the back.
2. Cut another 12” piece of wire and thread on two AB crystals. Leaving a 2” piece in the back, wrap wire around the flower and metal cuff making sure the crystals are in the flower center. Add two more crystals and wrap again. Add two more and wrap then add one to finish. Twist wire several times and wrap and tuck behind flower to hide.
3. Repeat steps 1 and 2 for the other flowers. Use three crystals for each flower center.
NOTE: Wrap flowers tightly around cuff so they don’t move around.