Directions:
1.Remove the union jack heart sticker from the release paper and place in the center of the front window on the box.
2.Remove one crown from the release paper and place in the center of the heart sticker.
3.Remove one large pearl and one rhinestone sticker from the Fancy Hat sticker set. Place the rhinestone in the center top of the crown sticker and the pearl on the center of the box closure.
4.To make flowers cut paper into squares using the trimmer. For the white card stock cut:
One 4”x4” square and two 2”x2”squares. For the blue paper cut one 5”x5” square, Two 4”x4”squares, three at 3”x3” squares and one at 2”x2”square.
5.Cut a spiral from each square, starting at the narrow outside edge, and get wider as you cut into the center of the spiral, See spiral template.
6.To wrap the spirals into rosettes, start with the outer thin end and work into the center of the rosette. Note; The outer end of the rosette will become the center. Rosettes are reversed rolled to form shapes. Roll the rosette somewhat tightly. Before gluing release the tension of the rosette slightly to form a looser flower. Hot glue the end at the bottom to hold in place. Put a dollop of hot glue on the bottom of the entire rosette to secure inner pieces. Continue process until all 10 rosettes are made.
7.To arrange the rosettes hot glue one large blue rosette to the right side of the handle on the lid. Begin building flowers around the lid. Be sure not to hot glue any flowers to inhibit lid from opening.
8.Cut out three leaves (two large one smaller) from green paper. Put a small dap of hot glue on one tip and tuck under the flowers as shown figure 1